Sansurfer windows agent

If there are odd values, or you have problems later, the QLogic card can be reset to factory defaults from the main BIOS screen. Once the values are set, go ahead and complete the boot up of the SAN server. The QLogic card is now ready to be paired with our initiator. It's harder than you think for that expensive router of yours to deliver all the throughput the big number on its box promises. We show you why. Trying to decide between a router and a Wi-Fi System?

This experiment should help you choose wisely. Updated: Here's a quick primer on Wi-Fi 6E. Wi-Fi ping spikes aren't always caused by a poor connection. Your router settings could be to blame. Ever wonder what happens behind the scenes when Wi-Fi devices roam, or more likely don't?

We'll show you why the "seamless" roaming Wi-Fi gear makers promise is still as elusive as a Yeti. We reveal the secrets of why your devices don't always connect where you want them to and what you can do to fix it. Wi-Fi Router Charts. Wi-Fi Router Ranker. Wi-Fi Router Finder. Mesh System Charts. Mesh System Ranker. Mesh System Finder. NAS How To. Discuss this in the Forums. Support Us! If you like what we do and want to thank us, just buy something on Amazon.

Download the program again, this time to a different directory; perform the installation. Cause: There is insufficient disk space or not enough available memory. Cause: There is insufficient memory. If the service is already started, stop and restart the service. If entries display, iqlremote is running. Refer to the system server information to check the system name. From the Connect to Host dialog box, select localhost. Use the Ping command to ping the host name; verify that the correct IP address is translated from the name.

Solution: Verify that the iqlremote agent is installed on the remote host. See Connecting to Hosts for instructions on how to configure and manage remote hosts. Verify that the appropriate network protocol is running. Cause: The iqlremote agent is not running. Solution: Start the iqlremote agent or reboot the system. Cause: Host IP address does not resolve to a host name.

Verify that the host on which the agent is running has a correct entry for the IP address and host name. Solution: Verify that the appropriate operating system driver is loaded. Refer to the readme. Verify that the iqlremote agent is running on the local or remote host.

Check agent logs for any problems while querying information see Exporting or saving Agent Activity Logs. Cause: An incorrect or unsupported operating system driver is installed. Solution: Refer to the readme. See Software Requirements for supported browsers and Adobe Acrobat version. Install Adobe Acrobat. If entries display, iqlremote is loaded. If the operating system cannot detect the HBA and all the above steps fail to fix the connection between the driver and the HBA, then reloading the driver or rebooting the operating system may clear up the problem.

Cause: There is a disconnect or the HBA lost communication with the target. Solution: Verify that the device is operational. For details about connection problems with a device, use the connection error log see Viewing the Connection Error Logs. Modify the HBA firmware parameters as necessary. Do one of the following: Review the target configuration parameters see Changing the Target Configuration Parameters and modify as necessary.

Reset the HBA's firmware parameters to the factory defaults see Restoring an HBAs Firmware Parameters to the factory Defaults ; then configure the specific device: delete the target, save, add the target, and save see Configuring Specific Targets.

If all the above steps fail to fix the connection, then rebooting the operating system may clear up the problem. Verify that the disk and system memory requirements are met. Cause: The iqlremote agent is not running or installed. Cause: The iqlremote agent is not running or is not installed. Solution: Install the appropriate HBA driver. Cause: The HBA is not installed. Solution: Install the HBA.